Isuzu 1999 RODEO Workshop Manual page 574

Hide thumbs Also See for 1999 RODEO:

Table of Contents

4. Place pre tensioned probe (6) of gauge on measuring

arm of measuring device J–43038. The probe must

be set precisely between the notch marks, square to

the plane surface (7).

5. Determine the left and right stops by turning the

knurled bolt (2).

Set the dial of the gauge to zero.

Use the knurled bolt (2) to move the 2nd balancer

shaft (exhaust side) back and forth. Again —

simultaneously read off the tooth backlash from the

The permissible tooth backlash is: 0.02 mm to

0.06 mm (0.0008 to 0.0024 in).

ENGINE MECHANICAL (X22SE 2.2L)

6. The tooth backlash must be measured in 4 different

positions — turn the crankshaft further at the

fastening bolt of the timing belt drive gear by 45° in the

engine rotational direction until the measuring arm (2)

is at "6 o'clock".

7. Then loosen the knurled bolt (3) fix the measuring arm

at "9 o'clock" again and repeat the measurement.

8. If the value determined in one of the 4 measurements

lies outside the tolerance 0.02 mm to 0.06 mm

(0.0008 to 0.0024 in), the tooth backlash must be

Show Quick Links

Chapters

Table of Contents