Intake Air Temperature (Iat) Sensor - Isuzu 1999 RODEO Workshop Manual

6E1–386 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
Installation Procedure
NOTE: If HO2S is reinstalled after removal, special
anti–seize compound or the equivalent should be applied
to the threads. Special anti–seize compound, (P/N
5613695), is used on the HO2S threads. This compound
consists of glass beads suspended in a liquid graphite
solution. The graphite burns away with exhaust heat, but
the glass beads will remain, making the sensor easier to
remove.
1. Apply anti–seize compound or the equivalent to the
thread.
2. Install HO2S on the exhaust pipe.
3. Tighten the sensor to 55 Nm (40 lb ft)
4. Connect the pig tail to the wiring harness.
5. Connect the negative battery cable.
(Pre–Catalytic Converter Heater Oxygen Sensor Loca-
tion)
(Post–Catalytic Converter Heater Oxygen Sensor
Location)
Intake Air Temperature (IAT)
Removal Procedure
1. Disconnect the negative battery cable.
2. The IAT sensor is located in the intake air duct
between the air filter and the throttle body.
TS23739
3. Disconnect the electrical connector from the sensor.
014RX010
Sensor
014RX009
014RX011