Fuel Tank - Isuzu 1999 RODEO Workshop Manual

6E1–410 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION

Fuel Tank

Removal Procedure
1. Disconnect the negative battery cable.
2. Remove fuel filer cap.
3. Drain the fuel from fuel filler neck.
4. Disconnect the fuel filler hose at fuel tank.
5. Disconnect the air breather hose at the fuel tank.
6. Disconnect the evaporator hose at the fuel tank.
7. Hold entire fuel tank at the bottom with stands.
8. Disconnect fuel supply lines and fuel return line at
near the fuel filter inside of body frame.
9. Remove four bolts (two in front and two in rear)
holding fuel tank to the frame.
10. Lower tank assembly from the vehicle a little to make
access space on top.
11. Disconnect two electrical connectors at fuel pump.
12. Remove fuel tank assembly from the vehicle.
13. Remove four nuts retaining tank under guard to the
tank.
14. Remove the tank from the guard.
Installation Procedure
1. Secure fuel tank into under guard with four retaining
bolts, if necessary.
2. Place the fuel tank assembly onto stands.
3. Lift the fuel tank assembly near the position.
4. Connect two electrical connectors at fuel pump.
5. Lift the fuel pump to its position and secure it with four
mounting bolts. Make sure that all hoses and fuel
041RX005
lines are out of way between the fuel tank and the fuel
tank bracket. Tighten the fuel tank retaining bolts to
36 Nm (27 lb ft).
6. Connect fuel supply and return lines.
041RX006
041RX002
041RX007