Isuzu 1999 RODEO Workshop Manual page 612

f Replace spark plugs if measured value is out of
standard.
Insulation resistance: 50 MW or more
Cleaning Spark Plugs
f Clean spark plugs with a spark plug cleaner.
f Raise the ground electrode to an angle of 45 to 60
degrees. if electrode is wet,dry it before cleaning.
f After spark plug is thoroughly cleaned,check insulator
for presence of cracks.
Removal
1. Disconnect battery ground cable
2. Wiring connector from crankshaft angle sensor.
3. Remove crankshaft angle sensor from cylinder block.
011RS010
Installation
Crankshaft Angle Sensor
Installation
015RW021
IGNITION SYSTEM (X22SE 2.2L)
f Clean threads and metal body with a wire brush.
f File the electrode tip if electrode is extremely worn.
f Bend the ground electrode to adjust the spark plug
gap.
1. Spark plugs
f Tighten spark plugs to the specified torque.
Torque: 25 N·m (18 lb ft)
1. Install crankshaft angle sensor into the cylinder block.
Before installation,apply small amount of engine oil to
the O–ring.
Torque: 6 N·m (4 lb ft)
2. Reconnect wiring connector to crankshaft angle
sensor.
6D2–3
011RS011