Knock Sensor - Isuzu 1999 RODEO Workshop Manual

7. Connect the negative battery cable.
IMPORTANT: Use an identical replacement part in
order to replace a valve. IAC valve pintle shape and
diameter are designed for the specific application.

Knock Sensor

Removal Procedure
1. Disconnect negative battery cable.
2. Disconnect pig tail electrical connector at near the top
of generator.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
014RX011
014RX027
3. Unscrew retaining bolt from Knock Sensor located
passenger side of engine block just front of starter.
4. Remove Knock Sensor with retaining bolt.
Installation Procedure
1. Install Knock Sensor with retaining bolt.
2. Connect pig tail electrical connector.
3. Connect battery negative cable.
6E1–397
014RX028
014RX029