5. Install intake duct bracket with ground cable.
6. Install intake duct assembly to throttle body and air
cleaner then tighten nut to the intake duct bracket and
clamp on the throttle body side, also clamp air cleaner
cover.
Removal
1. Disconnect battery ground cable.
2. Move drive belt tensioner to loose side by using
wrench then remove drive belt.
3. Remove four crankshaft pulley fixing bolts, remove
crankshaft pulley.
ENGINE MECHANICAL (X22SE 2.2L)
7. Connect PCV hose to air intake duct.
8. Connect battery ground cable.
Crankshaft Pulley
Installation
1. Install the crankshaft pulley to crankshaft flange.
2. Tighten four bolt to the specified torque.
Torque: 20 N·m (14 lb ft)
033RW001
3. Move drive belt tensioner to loose side by using
wrench, then install drive belt to normal position.
020RW014
4. Connect battery ground cable.
6A–19
020RW014
033RW001