Inspection And Repair - Isuzu 1999 RODEO Workshop Manual

4C–4
DRIVE SHAFT SYSTEM
7. Remove outer bearing.
8. Remove oil seal.
9. Remove inner bearing.
10. Use a brass bar to remove the outer bearing outer
race(1), oil seal, inner bearing and inner bearing outer
race(2) from the hub.
11. Remove bolt.
12. If necessary, replace the wheel pin in the following
manner.
f Scribe mark(1) on hub to disc before disassembly
to insure proper assembly.
f Clamp hub and disc assembly in vise, using
protective pads.
retaining bolts.
f Place hub on a suitable work surface and remove
wheel studs, as required, using a hammer.
411RS002

Inspection and Repair

Check the following parts for wear, damage or other
abnormal conditions.
f Hub
f Hub bearing
411RS003
f Bearing outer race
f Disc
f Oil seal
Remove six(6) disc-to-hub
411RS021
411RS004