Disassembled View
Legend
(1) Bolt
(2) Cover and Gasket
(3) Lock Washer
(4) Hub Nut
(5) Outer Bearing
Disassembly
1. Before disassembly, jack up the front of vehicle and
support frame with jack stands.
2. Remove the two bolts from the rear side of the
knuckle arm, then remove the brake caliper, with the
brake hose attached.
Use a wire to attach the brake caliper to the upper link.
Refer to Disk Brakes in Brake section.
3. Remove cover bolt.
4. Remove cover and gasket.
5. Remove lock washer.
6. Remove hub nut, using front hub nut wrench
J–36827.
Front Hub and Disc (2WD Model)
DRIVE SHAFT SYSTEM
(6) Hub and Disc Assembly
(7) ABS Sensor Ring
(8) Inner Bearing
(9) Oil Seal
(10) Bolt
(11) Wheel Pin
4C–3
411RX001
901RW054