Removal; Installation; Parking Brake Lever - Isuzu 1999 RODEO Workshop Manual

5D2–2 PARKING BRAKE SYSTEM (4X2 Model)
Parking Brake Lever Assembly and Associated Parts
Legend
(1) Rear Console
(2) Switch Connector
(3) Bolt
(4) Adjust Nut and Lock Nut

Removal

1. Remove rear console (1).
f Refer to Body and Accessories section.
2. Disconnect switch connector (2).
3. Remove bolt (3).
4. Remove adjust nut and lock nut (4).
5. Pull out equalizer (6) from trunnion pin (5).
6. Disconnect trunnion pin (5) from parking brake lever
(8).
7. Disconnect parking brake rear cable (7).

Parking Brake Lever

(5) Trunnion Pin
(6) Equalizer
(7) Parking Brake Rear Cable
(8) Parking Brake Lever

Installation

1. Apply grease (BESCO L–2 or equivalent) to the
connecting portion of the rear cable (7) and equalizer
(8).
2. Connect parking brake rear cable (7) to equalizer (6).
3. Install trunnion pin (5) to parking brake lever (8).
4. Insert equalizer (6) into trunnion pin (5) and tighten
adjust nut and lock nut (4).
f To adjust the parking brake lever, see "Parking
Lock Nut Torque: 13 N·m (113 lb in)
5. Tighten parking lever fixing bolt (3) to the specified
torque.
Torque: 15 N·m (11 lb ft)
6. Connect switch connector (2).
7. Install rear console (1).
f Refer to Body and Accessories section.
Brake Adjustment" in this section.
311RW008