6E1–354 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
DTC P1640 –Output Driver Module (ODM) "A" Fault (Cont'd)
Step
11
Repair the short to ground between the affected
component and its PCM driver terminal.
Is the action complete?
12
Repair the open circuit between the fuse and the PCM
driver terminal for the affected circuit.
Is the action complete?
13
1. Connect the PCM.
2. Start the engine and let it idle.
3. Backprobe the affected terminal at the PCM with a
DVM.
Was the voltage equal to the specified value?
14
1. Run the engine at idle.
2. Check for battery voltage at the fuse for the affected
circuit.
Was battery voltage available at the fuse?
15
Replace the PCM.
IMPORTANT: The
programmed.
Powertrain
Control
procedures.
And also refer to latest Service Bulletin.
Check to see if the Latest software is released or not.
And then Down Load the LATEST PROGRAMMED
SOFTWARE to the replacement PCM.
Is the action complete?
Action
replacement
PCM
Refer to On-Vehicle Service in
Module
and
Sensors
Value(s)
—
—
B+
—
must
be
for
—
Yes
No
Verify repair
—
Verify repair
—
Go to Step 15
Go to Step 14
Go to Step 10
Go to Step 9
Verify repair
—