Throttle Body (Tb) - Isuzu 1999 RODEO Workshop Manual

7. Connect the fuel filler hose, the air breather hose and
EVAP hose onto fuel tank and secure them with
clamps.
8. Pour fuel into fuel tank.
9. Install fuel filler cap securely.
10. Connect the battery negative cable.

Throttle body (TB)

Removal Procedure
1. Disconnect the negative battery cable.
2. Drain the cooling system. Refer to Cooling System.
3. Remove the air intake duct. Refer to Air Intake Duct
Removal Procedure.
4. Remove the accelerator cable from throttle. Refer to
Accelerator Cable Assembly Removal Procedure.
5. Disconnect the electrical connectors from the throttle
position sensor and the idle air control valve solenoid.
6. Disconnect all vacuum hoses below air horn.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
041RX006
041RX005
7. Disconnect coolant lines.
8. Remove the mounting bolts retaining the throttle body
the intake manifold.
9. Lift up the throttle body from the intake manifolds.
10. Remove the gaskets from the intake manifolds.
11. Remove the IAC. Refer to Idle Air Control Valve
Solenoid Removal Procedure.
12. Remove TPS. Refer to Throttle Position Sensor
Removal Procedure.
Inspection Procedure
NOTE: Do not use solvent of any type when you clean the
gasket surfaces on the intake manifold and the throttle
body assembly. The gasket surface and the throttle body
assembly may be damaged as results.
1. If the throttle body gasket needs to be released,
remove any gasket material that may be stuck to the
mating surfaces of the manifold.
6E1–411
014RX025
014RX040