6H–2
ENGINE SPEED CONTROL SYSTEM (X22SE 2.2L)
Removal
1. Loosen the nut(5) on the cable bracket mounted.
2. Remove cable clip(3).
3. Disconnect accelerator pedal (AP) control cable(6).
(on throttle valve side)
4. Disconnect AP control cable(1). (on AP pedal(7) side)
5. Remove grommet(2).
6. Remove AP control cable(4).
Inspection
Check the following items, and replace the control cable if
any abnormality is found:
f The control cable should move smoothly.
f The control cable should not be bent or kinked.
f The control cable should be free of damage and
corrosion.
Accelerator Pedal Control Cable
Installation
1. Install AP control cable(4).
2. Install grommet(2).
3. Connect AP control cable(1). (on AP pedal(7) side)
4. Connect AP control cable(6). (on throttle valve side)
5. Install cable clip(3).
6. Install nut(5).
035RX004