Cylinder Head Cover; Removal - Isuzu 1999 RODEO Workshop Manual

6A–16 ENGINE MECHANICAL (X22SE 2.2L)

Removal

1. Disconnect battery ground cable.
2. Disconnect PCV hose from cylinder head cover.
3. Remove intake duct.
4. Remove left side ground cable from cylinder head
cover and disconnect ground cable connector on the
left side wheel arch. Remove right side ground cable
from generator stay and disconnect ground cable
connector on the right side wheel arch.
5. Disconnect three(black, green and blue colors)
engine wire harness connectors from chassis
harness of left rear side of compartment.
6. Disconnect cooling fan wire harness connector from
cooling fan on left side top of fan shroud.
7. Move drive belt tensioner to loose side using wrench
then remove drive belt.
8. Remove PCV hose from cylinder block.
9. Remove intake duct stay from cylinder head.
10. Remove two bolts for remove ignition cable cover
from cylinder head cover.
11. Disconnect ignition cable from ignition plug.
12. Disconnect camshaft position sensor harness and
crankshaft angle sensor harness from behind
generator.

Cylinder Head Cover

13. Remove four bolts and remove the crankshaft pulley
14. Remove timing belt front cover.
15. Loose fixing bolt of timing belt rear cover then remove
the camshaft angle sensor.
033RW001
16. Remove ten cylinder head cover fixing bolts and
remove the cylinder head cover.
020RW014
020RW012