6E1–338 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
Step
1
Was the "On–Board Diagnostic (OBD) System Check
performed?
2
1. Turn the ignition switch ON, with the engine OFF.
2. Review and record the Tech 2 Failure Records data,
the clear the DTCs.
3. Operate the vehicle within the Failure Records
conditions noted.
4. Using the Tech 2, monitor "DTC" info for DTC
P1404.
Does the Tech 2 indicate DTC P1404 "Ran and
Passed"
3
1. Ignition OFF.
2. Disconnect the Linear Exhaust Gas Recirculation
(EGR) Valve from the wiring harness.
3. Ignition ON, Engine OFF.
4. Using a Digital Voltmeter (DVM), check for voltage
on the Ignition feed circuit at the Linear Exhaust Gas
Recirculation
connector.
Does the DVM read the following value?
4
Check the Ignition feed circuit, between the EGR
sensor and the "Engine IG." fuse, for the following
conditions:
f
An Open circuit
f
A short to ground
Was the problem found?
5
Using a DVM, check the resistance of the EGR
solenoid.
Does the DVM read the following value?
6
Check the EGR solenoid valve Low circuit, between the
EGR sensor and the PCM, for the following conditions:
f
An Open circuit
f
A short to ground
Was the problem found?
7
1. Ignition OFF.
2. Disconnect the Linear Exhaust Gas Recirculation
(EGR) Valve from the wiring harness.
3. Ignition ON, Engine OFF.
4. Observe the EGR value on the Tech 2.
Does the Tech 2 display the following value(s)?
8
Check the EGR position feedback circuit, between the
EGR sensor and the PCM, for the following conditions:
f
An Open circuit
f
A short to ground
Was the problem found?
DTC P1404 EGR Closed Valve
Action
(EGR)
Valve
wiring
Value(s)
—
—
harness
12 volts
—
less than 5 W
—
0 volts 0%
—
Yes
No
Go to OBD
System
Go to Step 2
Check
Refer to
Diagnostic
Aids
Go to Step 3
Go to Step 6
Go to Step 4
Verify repair
—
Go to Step 14
Go to Step 6
Go to Step 15
Verify repair
Go to Step 9
Go to Step 8
Go to Step 15
Verify repair