Emissions Catalytic Converter; Air Conditioning Relay; Ignition Timing Adjustment; Evap Canister Hoses - Isuzu 1999 RODEO Workshop Manual

6E1–416 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION

EMISSIONS Catalytic Converter

Catalytic Converter
Refer to Engine Exhaust.

Air Conditioning Relay

Removal Procedure
1. Remove the fuse and relay box cover at right side of
engine room.
2. Refer to the diagram on the cover to determine which
is the correct relay.
3. Insert small screwdriver or use thumb pressure to
release the retainer of the relay.
4. Pull the relay straight up and out of the fuse and relay
box.
Installation Procedure
1. Insert the relay into the correct place in the fuse and
relay box with the catch slot aligned to retainer.
2. Press down until the catch of retainer engages.
3. Install fuse and relay box cover.

Ignition Timing Adjustment

Ignition Timing Adjustment
There is no timing adjustment. The timing signal is
furnished by the CKP and the CMP signal. PCM control
the ignition timing.

EVAP Canister Hoses

EVAP Canister Hoses
To see the routing of the EVAP canister hoses, refer to
Vehicle Emission Control Information in Diagnosis or
Emission Label located bottom side ofthe hood. Use
6148M or equivalent when you replace the EVAP canister
hoses.
Removal Procedure
1. Disconnect all hoses.
2. Remove two mounting bracket nuts.
Inspection Procedure
1. Inspect the hoses for cracks, damage and leaks.
2. Inspect the canister for damages.
Installation Procedure
014RX052
1. Install EVAP canister onto crossmember with two
mounting bolts.
2. Connect all hoses and secure them with clamps.

EVAP Canister

014RX001
014RX054