Rear Axle Brake Hose; Rear Axle Brake Hose And Associated Parts; Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Rear Axle Brake Hose and Associated
Parts
Legend
(1) Brake Pipe
(2) Clip
(3) Bolt
(4) Brake Pipe
(5) Hose
POWER–ASSISTED BRAKE SYSTEM

Rear Axle Brake Hose

Removal

1. Raise the vehicle and support it with suitable safety
2. Remove wheel and tire assembly.
3. Clean dirt, grease, and other foreign material off the
4. Disconnect brake pipe.
5. Remove clip.
6. Remove brake pipe.
7. Remove bolt.
8. Remove hose.

Installation

To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the brake pipes to the specified torque
Torque: 16 N·m (12 lb ft)
2. Tighten the bolt to the specified torque.
Torque: 15 N·m (11 lb ft)
352RW002
After installing the brake hoses, bleed the brakes as
described in this section.
stands.
hose fittings at both ends.
5C–13