Power Steering Pump; Power Steering Pump And Associated Parts 2A-22 Removal; Installation - Isuzu 1999 RODEO Workshop Manual

2A–22 POWER–ASSISTED STEERING SYSTEM
Power Steering Pump and Associated Parts
Legend
(1) Pump Assembly
(2) Hose, Suction
Removal
1. Remove the drive belt.
2. Place a drain pan below the pump.
3. Disconnect the suction hose.
4. Disconnect the flexible hose.
5. Remove the power steering fixing bolt and remove
the pump assembly.

Power Steering Pump

(3) Hose, Flexible
(4) Bolt

Installation

1. Install the pump assembly to the pump braket, tighten
Torque: 46 N·m (34 lb ft)
2. Install the flexible hose.
Torque: 54 N·m (40 lb ft)
3. Install the drive belt.
4. Connect the suction hose, then fill and bleed system.
the fixing bolt to the specified torque.
Tighten the eye bolt to specified torque.
Refer to Bleeding the Power Steering System in this
section.
436RX001