Disc Plate, Screw Installation Note - Mazda CX-7 2007 Workshop Manual

Disc Plate, Screw Installation Note

1. Measure the inner diameter of the disc plate with
a vernier caliper.
• If it exceeds the maximum diameter, install
the new disc plate.
Maximum rear disc plate inner diameter
191.0 mm {7.52 in}
2. Install the disc plate and screw.
3. Perform the following steps to adjust the shoe
clearance after installing the disc plate and the
screws.
(1) Insert a flathead screwdriver into the service
hole and turn the adjuster in the direction of
the arrow to expand the parking brake shoe
until the disc plate cannot rotate.
(2) Return the adjuster 13—17 notches in the
direction of the arrow.
Note
• Shoe clearance can be adjusted to 0.15 mm
{0.006 in} by returning the adjuster 15
notches.
(3) Rotate the disc plate and make sure it does
not drag.
04-12–12
PARKING BRAKE SYSTEM
LEFT SIDE
LEFT SIDE
acxuuw00001055
RIGHT SIDE
acxuuw00001056
RIGHT SIDE
acxuuw00001057