Mazda CX-7 2007 Workshop Manual page 1053

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
12. Apply sealant to the new control valve body cover
as shown in the figure.
Caution
• Be careful that the coupler component
will not become caught between the
control valve body cover and transaxle
case.
13. Install the new control valve body cover with new
seal bolts.
Tightening torque
9.8— 15.7 N·m {100— 160 kgf·cm, 87— 138
in·lbf}
14. Install the thermo valve. (See 05-17-47 OIL
COOLER REMOVAL/INSTALLATION[AW6A-EL,
AW6AX-EL].)
15. Install the resonance chamber. (See 01-13-5
INTAKE AIR SYSTEM REMOVAL/
INSTALLATION[L3 WITH TC].)
16. Install the TCM. (See 05-17-25 TCM REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
17. Add ATF to the specified level. (See 05-17-11
AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
18. Install the under cover.
19. Install the air cleaner component. (See 01-13-5
INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
20. Connect the negative battery cable.
21. Perform the mechanical system test. (See 05-17-3 MECHANICAL SYSTEM TEST[AW6A-EL, AW6AX-EL].)
End Of Sie
OIL SEAL (OIL PUMP) REPLACEMENT[AW6A-EL, AW6AX-EL] WM: TORQUE CONVERTER
1. Remove the transaxle. (See 05-17-29 AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION[AW6A-EL,
AW6AX-EL].)
Caution
• The oil seal is easily damaged by the sharp edges of the torque converter splines. Do not let the
splines contact the oil seal.
• Do not drop the torque converter.
• Do not pinch fingers.
2. Remove the torque converter. (See 05-17-46 TORQUE CONVERTER REMOVAL/INSTALLATION[AW6A-EL,
AW6AX-EL].)
Caution
• Do not to damage the bushing on the oil pump body.
acxuuw00000603
05-17
acxuuw00000585
id051723800800
05-17–45