Mazda CX-7 2007 Workshop Manual page 412

2. Temporarily tighten the bolts and nuts in the order
shown in the figure.
3. Tighten the bolts and nuts in the order shown in
the figure.
Tightening torque
74.5— 104.9 N·m {7.6— 10.6 kgf·m, 55.0—
77.3 ft·lbf}
Crankshaft Pulley Lock Bolt Installation Note
1. Install the SST to the camshaft as shown in the
figure.
2. Verify that cylinder No.1 is at TDC of the
compression stroke. (Position crank weight
contacts SST.)
3. To position the crankshaft pulley, temporarily
tighten it and, using a suitable bolt (M6 X 1.0
length 25— 35 mm {0.99— 1.3 in}), fix the
crankshaft pulley to the engine front cover.
4. Install theSSTs to the crankshaft pulley, lock the
crankshaft against rotation, and tighten the
crankshaft pulley lock bolt using the following two
steps.
Tightening procedure
(1) 96— 104 N·m {9.8— 10.6 kgf·m, 70.9—
76.7 ft·lbf}
(2) 87°— 93°
01-10–18
MECHANICAL [L3 WITH TC]
2
3
FRONT
4
5
FRONT
(49 UN30 310610)
205-126
4
5
1
acxuuw00000241
1
2
3
acxuuw00000242
303-1061
acxuuw00000234
BOLT
acxuuw00000243
205-07202
acxuuw00002077