Mazda CX-7 2007 Workshop Manual page 1178

Stator and Thermal Protector Installation Note
1. Apply approx. 1 g {0.04 oz} of silicone (Shin-Etsu
Silicone KE-347W or similar) to the contact
surface of the thermal protector, then thoroughly
install it onto the A/C compressor, leaving no
gaps.
Screw Installation Note
1. When installing a new stator and thermal protector, replace the screw.
Clamp Installation Note
1. When installing a new stator and thermal protector, replace the clamp.
Snap Ring Installation Note
1. When installing a new pressure plate, A/C
compressor pulley, stator, or A/C compressor
body, replace the snap ring.
End Of Sie
MAGNETIC CLUTCH ADJUSTMENT
1. Measure the clearance around the entire
circumference between the pressure plate and A/
C compressor pulley using a thickness gauge.
2. Verify that the clearance is within the
specification.
• If not within the specification, remove the
pressure plate and adjust the clearance by
changing the shim (0.2 mm {0.008 in}, 0.5
mm {0.02 in}) or the number of shims.
Magnetic clutch clearance
0.3— 0.5 mm {0.012— 0.019 in}
End Of Sie
07-40–6
CONTROL SYSTEM
SNAP RING
SHAFT
PRESSURE PLATE
SILICONE
SEALANT
A/C COMPRESSOR
PULLEY
A/C COMPRESSOR
PULLEY
SHIM
A/C COMPRESSOR
acxuuw00002310
acxuuw00002311
id074000800500
acxuuw00001569
acxuuw00001570