Mazda CX-7 2007 Workshop Manual page 786

PID/Data Monitor and Record Procedure
1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
1. Select the "Toolbox" tab.
2. Select "DataLogger".
3. Select "Module".
4. Select "ABS".
• When using the PDS (pocket PC)
1. Select "Module Tests".
2. Select "ABS".
3. Select "DataLogger".
3. Select the applicable PID from the PID table.
4. Verify the PID data according to the directions on
the screen.
Note
• The PID/Data monitor function is used for monitoring the calculated value. Therefore, if the monitored
value of the output parts is not within the specification, inspection of the monitored value of input parts
corresponding to applicable output part control is necessary. In addition, because the system does not
display output part malfunction as abnormality in the monitored value, it is necessary to inspect the output
part individually using a active command modes function.
Active Command Modes Procedure
1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
1. Select the "Toolbox" tab.
2. Select "DataLogger".
3. Select "Module".
4. Select "ABS".
• When using the PDS (pocket PC)
1. Select "Module Tests".
2. Select "ABS".
3. Select "DataLogger".
3. Select the active command modes from the PID
table.
4. Perform the active command modes, inspect the operations for each parts.
• If there is no operation sound from the relay, motor, and solenoid after the active command mode
inspection is performed, it is possible that there is an open or short circuit in the wiring harness, relay, motor
or solenoid, or sticking and operation malfunction.
04-02–4
ON-BOARD DIAGNOSTIC
DLC-2
DLC-2
acxuuw00001207
acxuuw00001207