Disc Plate, Screw Installation Note; End Cable Installation Note - Mazda CX-7 2007 Workshop Manual

Disc Plate, Screw Installation Note

1. Measure the inner diameter of the disc plate with
a vernier caliper.
• If it exceeds the maximum diameter, install
the new disc plate.
Maximum rear disc plate inner diameter
191.0 mm {7.52 in}
2. Install the disc plate and screw.
3. Perform the following steps to adjust the shoe
clearance after installing the disc plate and the
screws.
(1) Insert a flathead screwdriver into the service
hole and turn the adjuster in the direction of
the arrow to expand the parking brake shoe
until the disc plate cannot rotate.
(2) Return the adjuster 13—17 notches in the
direction of the arrow.
Note
• Shoe clearance can be adjusted to 0.15 mm
{0.006 in} by returning the adjuster 15
notches.
(3) Rotate the disc plate and make sure it does
not drag.

End Cable Installation Note

1. Move the rear parking brake cable end in the
direction shown in the figure and install it to the
end cable.
2. Verify that the end cable tab (rear parking brake
cable side) is attached properly to the rear
parking brake cable end.
3. Install the end cable to the operation lever.
4. Install the end cable installation bolts.
End Of Sie
PARKING BRAKE SYSTEM
LEFT SIDE
LEFT SIDE
END CABLE
TAB
REAR PARKING BRAKE CABLE
acxuuw00001055
04-12
RIGHT SIDE
acxuuw00001056
RIGHT SIDE
acxuuw00001057
acxuuw00001870
04-12–7