Mazda CX-7 2007 Workshop Manual page 1284

Passenger-side Air Bag Module
Warning
• The passenger-side air bag module is a dual inflator type. If one inflator is forced to operate
(deploy), the other may operate (deploy) accidentally. To prevent injury while disposing of the air
bag module, make sure to operate (deploy) both passenger-side air bag module inflators
simultaneously, following the procedure below.
1. Remove the passenger-side air bag module.
(See 08-10-7 PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)
2. Install the bolts to the passenger-side air bag
module.
3. Connect the SSTs (Adapter harness) to the
passenger-side air bag module as shown in the
figure.
4. Place the padded surface of the passenger-side
air bag module facing the center of the tire as
shown in the figure. To secure the air bag module
to the tire wheel, wrap a wire (cross section 1.25
2 2
mm {0.002 in } or more) through the tire and
around the bolts at least 4 times as shown in the
figure.
Warning
• If the air bag module is not properly
secured to the tire, the tires may fall over
by the impact of operation (deployment)
and cause serious injury. To prevent this,
secure the air bag module properly with
the padded surface facing the center of the tire.
08-10–24
AIR BAG SYSTEM
PASSENGER-SIDE
AIR BAG MODULE
49 G066 003
PASSENGER-SIDE
AIR BAG MODULE
BOLT
PASSENGER-SIDE
AIR BAG MODULE
WIRE
acxuuw00001710
49 L066 002
acxuuw00001711
TIRE
acxuuw00001712