Mazda CX-7 2007 Workshop Manual page 401

23. Carefully apply adhesive agent (Loctite 518 or
962) to the area indicated in the figure so that it
does not leak into the sliding part.
Thickness
1.0 mm {0.039 in}
24. Install the camshaft caps and temporarily tighten
the camshaft cap bolts evenly in two or three
passes, and then tighten the camshaft cap bolts
in two passes, using the following two steps and
in the order shown in the figure.
Tightening procedure
1. 5.0— 9.0 N·m {51— 91 kgf·cm, 45— 79
in·lbf}
2. 14.0— 17.0 N·m {1.5— 1.7 kgf·m, 10.4—
12.5 ft·lbf
25. Install the OCV. (See01-10-29 OIL CONTROL
VALVE (OCV) REMOVAL/INSTALLATION[L3
WITH TC].)
26. Install a new washer.
27. Install the exhaust camshaft sprocket.
Caution
• Do not tighten the camshaft sprocket
installation bolt at this stage. Verify the
valve timing before performing the bolt
tightening.
Revised 3/2007 (Ref. No. R051/07)
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
MECHANICAL [L3 WITH TC]
INTAKE REAR CAMSHAFT CAP
5
3 1
EX
No.1 No.2 No.3
IN
5
3 1
R
EXHAUST
CAMSHAFT
SPROCKET
SEALANT SEALANT
01-10
acxuuw00000164
2
No.4
2 4 6
acxuuw00000165
acxuuw00000166
acxuuw00000162
01-10–7