Mazda CX-7 2007 Workshop Manual page 418

2
R
SST
1
96—104 {9.8—10.6 , 70.9—76.7} +87
1 Crankshaft pulley lock bolt
(See01-10-24 Crankshaft Pulley Lock Bolt Removal
Note.)
(See01-10-25 Crankshaft Pulley Lock Bolt Installation
Note.)
Crankshaft Pulley Lock Bolt Removal Note
1. Rotate the crankshaft in the direction of the
engine rotation and remove the cylinder block
lower blind plug when the No. 1 cylinder is at the
point prior to top dead center (TDC) of
compression, then install the SST.
2. Rotate the crankshaft in the direction of the
engine rotation so that the No.1 piston is at TDC
of the compression stroke. (Until the crank weight
contacts SST and stops.)
3. Install the SSTs to the crankshaft pulley and lock
the crankshaft against rotation.
01-10–24
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
MECHANICAL [L3 WITH TC]
R
3
R SST
OIL OIL
˚ ˚
—93
2 Crankshaft pulley
3 Front oil seal
(See01-10-25 Front Oil Seal Removal Note.)
(See01-10-25 Front Oil Seal Installation Note.)
303-507
205-126
N·m { kgf·m, ft·lbf}
acxuuw00002584
acxuuw00001897
205-07202
acxuuw00002079