Mazda CX-7 2007 Workshop Manual page 1072

AUTOMATIC TRANSAXLE SHIFT MECHANISM
4. Verify that the manual shaft is in the P position.
Caution
• Bending the selector cable in the manner
shown in the figure will damage the cable
and it may become loose when shifted.
When installing the selector cable, hold it
straight.
5. Install the clip as shown in the figure.
Note
• Install the selector lever to the manual shaft
lever with the clip side of the selector cable
end facing up.
6. Install the selector lever to the manual shaft lever
so that no load acts on the selector cable.
7. Confirm that the tip of the manual shaft lever
projects out of the end of the selector cable.
8. Securely install the selector cable to the selector
cable bracket.
Interlock Cable Installation Note
1. Push the interlock cable.
2. Verify that the marking on the slider pin is
positioned as shown in the figure.
05-18–10
CLIP
SELECTOR CABLE
MANUAL SHAFT LEVER
INTERLOCK CABLE
LOCK UNIT
BRACKET
DO NOT BEND
acxuuw00000432
CLIP
acxuuw00000433
UPWARD
acxuuw00000422
acxuuw00000423
acxuuw00000424