Mazda CX-7 2007 Workshop Manual page 1270

CRASH ZONE SENSOR REMOVAL/INSTALLATION
Warning
• Handling the crash zone sensor improperly can accidentally deploy the air bags and pre-tensioner
seat belts, which may seriously injure you. Read the air bag system service warnings and cautions
before handling the crash zone sensor. (See 08-10-3 AIR BAG SYSTEM SERVICE WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM SERVICE CAUTIONS.)
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the front bumper. (See 09-10-2 FRONT BUMPER REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
1 Bolt A
2 Cover
3 Connector
(See 08-10-10 Connector Removal Note.)
4 Bolt B
5 Crash zone sensor
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position.
7. Verify that the air bag system warning light
illuminates for approx. 6 s and goes out.
• If the air bag system warning light does not
operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the
system.
Connector Removal Note
1. Disconnect the connector from the crash zone
sensor by pressing the connector tab and pulling
out the lock lever in the direction of the arrow.
End Of Sie
WM: SAS UNIT
SAS CONTROL MODULE REMOVAL/INSTALLATION
Warning
• Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-
tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and
cautions before handling the air bag module. (See 08-10-3 AIR BAG SYSTEM SERVICE
WARNINGS.) (See 08-10-5 AIR BAG SYSTEM SERVICE CAUTIONS.)
• Connecting the SAS control module with the SAS control module not securely fixed to the vehicle
is dangerous. When the ignition switch is turned to the ON position, the SAS control module could
tilt causing the SAS control module to detect that the vehicle is in a rollover condition, which may
accidentally operate (deploy) the curtain air bag module and pre-tensioner seat belt. Therefore,
before turning the ignition switch to the ON position with the connector connected, securely fix
the SAS control module to the vehicle.
Caution
• Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-
tensioner seat belt, which may seriously injure you. If configuration is not completed before
removing the SAS control module, DTC B2477 or B1017 will be displayed.
1. Perform SAS control module configuration when replacing it. (See 08-10-11 SAS CONTROL MODULE
CONFIGURATION.)
2. Turn the ignition switch to the LOCK position.
08-10–10
AIR BAG SYSTEM
5
3
4
8.8—12.8
{89.8—130.5,
N·m {kgf·cm, in·lbf}
77.8—113.2}
TAB
LOCK LEVER
CONNECTOR
id081000800500
8.0—11.0
{82—112,
71—97}
acxuuw00000642
acxuuw00000643
id081000801400