Mazda CX-7 2007 Workshop Manual page 873

2. Remove the battery tray bracket as shown in the
figure.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. After installation, add brake fluid, bleed the air,
and inspect for fluid leakage. (See 04-11-3 AIR
BLEEDING.)
6. After installation, perform the combined sensor
initialization procedure. (See 04-15-17
COMBINED SENSOR INITIALIZATION
PROCEDURE.)
7. After installation, perform the steering angle
sensor initialization procedure. (See 09-40-8
STEERING ANGLE SENSOR INITIALIZATION
PROCEDURE.)
7.8—10.8
{80—110, 70—95}
*
SST
49 0259 770B
*
E
COMMERCIALLY AVAILABLE FLARE NUT WRENCH
(FLARE NUT ACROSS FLAT 10 mm {0.39 in})
.
1 Brake pipe (DSC HU/CM— master cylinder)
2 DSC HU/CM connector
(See 04-15-8 DSC HU/CM Connector Removal
Note.)
(See 04-15-9 DSC HU/CM Connector Installation
Note.)
DYNAMIC STABILITY CONTROL
12.8—21.6
{131—220,
114—191}
5
BATTERY TRAY BRACKET
18—26 N·m
{1.9—2.6 kgf·m,
14—19 ft·lbf}
*
E
12.8—21.6
{131—220, 114—191}
*
SST
2
3 Brake pipe
(See 04-15-8 Brake Pipe Removal Note.)
(See 04-15-8 Brake Pipe Installation Note.)
4 Nut
5 DSC HU/CM
(See 04-15-8 DSC HU/CM Installation Note.)
04-15
acxuuw00001864
N·m {kgf·cm, in·lbf}
acxuuw00001878
04-15–7