Mazda CX-7 2007 Workshop Manual page 832

BRAKE PEDAL REMOVAL/INSTALLATION
Caution
• The clearance between the brake switch and the brake pedal is automatically adjusted to the
correct amount when the brake switch is inserted into the installation hole on the brake pedal and
rotated to fix in place. If the brake switch is not properly installed, the clearance may be incorrect,
causing a brake light malfunction. Therefore, always verify that the brake pedal is properly
installed and fully released before installing the brake switch to the pedal.
• Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again.
Therefore, replace the switch with a new one when replacing the power brake unit or the pedal, or
performing any procedure that changes the pedal stroke.
1. Remove the battery and battery tray. (See 01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC].)
2. Remove the battery tray bracket as shown in the
figure.
3. Disconnect the brake fluid level sensor connector.
4. Remove the master cylinder reserve tank bracket
installation nuts. (See 04-11-10 MASTER
CYLINDER REMOVAL/INSTALLATION.)
5. Remove the accelerator pedal. (See 01-13-17
ACCELERATOR PEDAL REMOVAL/
INSTALLATION[L3 WITH TC].)
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
4
.
1 Brake switch connector
(See 04-11-8 Brake Switch Connector Installation
Note.)
2 Brake switch
(See 04-11-8 Brake Switch Installation Note.)
04-11–6
CONVENTIONAL BRAKE SYSTEM
5
B
A
A
18.6—25.5
{1.90—2.60,
13.8—18.8}
R
C
18—26 N·m
{1.9—2.6 kgf·m,
14—19 ft·lbf}
B
18.6—25.5
{1.90—2.60,
13.8—18.8}
C
3 Interlock cable
(See 05-18-2 INTERLOCK CABLE ADJUSTMENT.)
4 Noise filter
5 Snap pin
6 Clevis pin
id041100801200
BATTERY TRAY BRACKET
acxuuw00001908
N·m {kgf·m, ft·lbf}
acxuuw00001743