Mazda CX-7 2007 Workshop Manual page 1236

STEP
5 INSPECT WIRING HARNESS BETWEEN
CLOCK SPRING AND SAS CONTROL
MODULE
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable and
wait for 1 min or more.
• Remove the column cover. (See 09-17-8
COLUMN COVER REMOVAL/
INSTALLATION.)
• Disconnect the clock spring connector.
• Remove the glove compartment.(See 09-17-
8 GLOVE COMPARTMENT REMOVAL/
INSTALLATION.)
• Disconnect the passenger-side air bag
module connector.
• Disconnect the driver and passenger-side
seat connectors.
• Remove the C-pillar trim. (See 09-17-17 C-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Remove the D-pillar trim. (See 09-17-18 D-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Disconnect the driver and passenger-side
curtain air bag module connector.
• Remove the B-pillar lower trim. (See 09-17-
16 B-PILLAR LOWER TRIM REMOVAL/
INSTALLATION.)
• Disconnect the driver and passenger-side
pre-tensioner seat belt connectors.
• Remove the console. (See 09-17-13
CONSOLE REMOVAL/INSTALLATION.)
• Disconnect the SAS control module
connector.
• Inspect the wiring harness between SAS
control module terminal 1G and clock spring
terminal 1B, SAS control module terminal 1J
and clock spring terminal 1A for the
following:
— Short to ground
— Short to power supply
— Open circuit
• Is the wiring harness normal?
End Of Sie
08-02–34
ON-BOARD DIAGNOSTIC
INSPECTION
Yes Replace the SAS control module.
(See 08-10-10 SAS CONTROL MODULE REMOVAL/
INSTALLATION.)
No Replace the air bag wiring harness.
ACTION