Mazda CX-7 2007 Workshop Manual page 1036

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
Neutral Position Learning
1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
2. Connect the M-MDS to the DLC-2.
3. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
1. Select the "Power train".
2. Select "Transmission".
• When using the PDS (pocket PC)
1. Select "All Tests and Calibrations".
4. Then, select the "Transmission Learning".
5. Perform the N range learning according to the
directions on the screen.
• When "Operation Successful" is displayed,
shift the selector lever to the P position and
turn the ignition switch to the LOCK position,
then to the ON position after 5 s.
• If "Reinstall TCM properly and then try again" is displayed, perform the following inspection:
— Verify that the transaxle manual shaft is in the N position.
• If the manual shaft is in a position other than N, shaft it to the N position.
— Verify that the selector cable is adjusted properly.
• If the selector cable is not adjusted properly, adjust it. (See 05-18-7 SELECTOR CABLE
ADJUSTMENT.)
— Inspect the manual shaft lever for deformation.
• If there is any malfunction, replace the manual shaft lever.
6. Shift the selector lever from P position to D range, then verify that the positions of the selector lever and the
indicator are aligned.
• If there is any malfunction, inspect the DTC. (See 05-02-5 DTC TABLE[AW6A-EL, AW6AX-EL].)
End Of Sie
OIL SEAL (MANUAL SHAFT) REPLACEMENT[AW6A-EL, AW6AX-EL] WM: AUTOMATIC TRANSAXLE
Caution
• Water or foreign material entering the connector can cause a poor connection or corrosion. Be
sure not to allow water or foreign material on the connector when disconnecting.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See 01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH
TC].)
3. Remove the TCM. (See 05-17-25 TCM REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
Caution
• Do not damage the transaxle case.
• Do not damage the manual shaft.
4. Remove and discard the oil seal using a tape-
wrapped flathead screwdriver.
Caution
• Do not damage the oil seal.
05-17–28
DLC-2
acxuuw00000480
id051723802300
acxuuw00000533