Mazda CX-7 2007 Workshop Manual page 776

Companion Flange Assembly Note
1. Install the coupling case to the SSTs as shown.
2. Install the companion flange.
Locknut Assembly Note
1. Secure the companion flange using the SST, and
tighten a new locknut.
Tightening torque
167— 226 N·m {17.1— 23.0 kgf·m, 124— 166
ft·lbf}
End Of Sie
WM: DIFFERENTIAL OIL TEMPERATURE SENSOR
DIFFERENTIAL OIL TEMPERATURE SENSOR INSPECTION
Warning
• Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is
hot.
1. Disconnect the negative battery cable.
2. Disconnect the differential oil temperature sensor connector and remove the differential oil temperature sensor.
3. Wrap the differential oil temperature sensor with
plastic wrap and immerse it into a beaker filled
with water. Gradually raise the water temperature,
and measure resistance between differential oil
temperature sensor terminals A and B.
• If not as specified, inspect the harness for
continuity. If there is normal continuity
between the terminals, replace the differential
oil temperature sensor.
Differential oil temperature sensor specification
Water temperature (°C {°F})
4. Install the differential oil temperature sensor and connect the connector.
5. Connect the negative battery cable.
03-19–10
ALL WHEEL DRIVE (AWD)
0 {32}
10 {50}
20 {68}
30 {86}
40 {104}
50 {122}
60 {140}
70 {158}
80 {176}
49 L027 0A2
49 S120 710
B A
Resistance (kirohm)
91— 100
56— 61
35— 39
23— 25
14— 17
10— 11
7.1— 7.9
5.0— 5.6
3.6— 4.0
acxuuw00002358
acxuuw00001457
id031900800700
acxuuw00001458