Mazda CX-7 2007 Workshop Manual page 1043

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
Torque Converter Nuts Installation Note
1. Align the holes by turning the torque converter.
2. Insert a screwdriver through the converter
housing service hole, and lock the drive plate.
Caution
• Loosely and equally tighten the torque
converter nuts, then further tighten them
to the specified tightening torque.
3. Tighten the torque converter mounting nuts.
Tightening torque
34.3— 60.8 N·m {3.50— 6.19 kgf·m, 25.3—
44.8 ft·lbf}
Selector Cable Installation Note
1. Install the selector lever to the manual shaft lever
so that no load acts on the selector cable.
Note
• Install the selector lever to the manual shaft
lever with the clip side of the selector cable
end facing up.
2. Confirm that the tip of the manual shaft lever
projects out of the end of the selector cable.
End Of Sie
WM: OIL SEAL (DIFFERENTIAL)
OIL SEAL (DIFFERENTIAL) REPLACEMENT[AW6A-EL, AW6AX-EL]
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the ATF. (See 05-17-11 AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT[AW6A-EL, AW6AX-
EL].)
Caution
• The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines
contact the oil seal.
4. Remove the drive shaft. (See 03-13-12 FRONT DRIVE SHAFT REMOVAL/INSTALLATION.)
5. Remove the joint shaft. (2WD) (See 03-13-3 JOINT SHAFT REMOVAL/INSTALLATION[2WD].)
6. Remove the transfer and joint shaft. (AWD) (See 03-13-4 JOINT SHAFT REMOVAL/INSTALLATION[AWD].)
(See 03-16-3 TRANSFER REMOVAL/INSTALLATION.)
Caution
• Do not damage the transaxle case.
• Do not damage the differential case.
7. Remove the oil seal lip using a razor.
CLIP
SELECTOR CABLE
MANUAL SHAFT LEVER
acxuuw00000622
05-17
NUT
acxuuw00000632
UPWARD
acxuuw00000631
id051723800100
05-17–35