Bolt (Rear Upper Arm Outer Side And Rear Lateral Link Outer Side) Removal Note; Rear Crossmember Component Removal Note; Bolt (Rear Upper Arm Outer Side And Rear Lateral Link Outer Side) Installation Note; Rear Cross Bar Installation Note - Mazda CX-7 2007 Workshop Manual

2007 mazda cx-7

Hide thumbs Also See for CX-7 2007:

Table of Contents

Bolt (Rear Upper Arm Outer Side And Rear Lateral Link Outer Side) Removal Note

1. Raise the rear trailing link to the unloaded

condition with a jack.

• Jacking up the rear suspension to the no-

occupant position will lighten the force on the

bushing and make it easier to perform the

2. Remove the bolts (rear upper arm outer side and

rear lateral link outer side).

• Removing the crossmember is dangerous. The crossmember component could fall and cause

serious injury or death. Verify that the jack securely supports the crossmember component.

1. Support the crossmember component using a

jack and remove the nuts.

2. Remove the crossmember component.

1. Raise the rear trailing link to the unloaded

condition with a jack.

2. Tighten the bolts (rear upper arm outer side and

rear lateral link outer side).

1. Install the cross bar so that the triangular marking

is facing to the front of the vehicle.

REAR SUSPENSION

acxuuw00001979

acxuuw00001528

acxuuw00001979

acxuuw00001929

Show Quick Links

Table of Contents