Mazda CX-7 2007 Workshop Manual page 758

Bolt and Nut Removal Note
Caution
• Do not mark with a punch to prevent imbalance.
1. Before removing the nut, place alignment marks
on the companion flange (front) and constant
velocity joint, and on the companion flange (rear)
and yoke.
Propeller Shaft Installation Note
1. Align the alignment marks and install the propeller
shaft.
2. When installing a new propeller shaft, align the
rear differential companion flange mark with the
tag on the propeller shaft so that they are at the
nearest position, and assemble.
3. Perform a road test and verify that there is no
abnormal vibration or noise.
End Of Sie
03-15–4
PROPELLER SHAFT
FRONT
FRONT
REAR
REAR
TAG
acxuuw00001383
acxuuw00001383
MARKING
acxuuw00000572