Mazda CX-7 2007 Workshop Manual page 1269

4. Remove in the order indicated in the table.
3
TAB
TAB
SEC. A—A
1 Connector
(See 08-10-9 Connector Removal Note.)
2 Bolt
3 Clip
5. Install in the reverse order of removal.
6. When the ignition switch is turned to the ON position verify that the air bag system warning light illuminates for
approx. 6 s and goes out.
• If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air
bag system) and perform inspection of the system.
Connector Removal Note
1. Using flathead screwdriver, pry out the connector
stopper plate.
2. Disconnect the connector.
End Of Sie
WM: CRASH ZONE SENSOR
AIR BAG SYSTEM
4
A
A
3
2 8.8—12.8 {89.8—130.5,
77.8—113.2}
1
5
4 Hook
5 Curtain air bag module
N·m {kgf·cm, in·lbf}
acxuuw00000641
STOPPER
PLATE
acxuuw00000638
08-10–9
08-10