Mazda CX-7 2007 Workshop Manual page 1074

AUTOMATIC TRANSAXLE SHIFT MECHANISM
13. Install the interlock cable end to the cam pin on
the selector lever.
14. Fit the interlock cable in the U–groove in the
selector lever base plate and install the clip.
15. Press the interlock cable lock piece in until it is
locked.
Caution
• Applying a load to the interlock cable
while pressing the lock piece in can
affect the lock unit operation.
16. Remove the a 1.5mm {0.059 in} round bar or
similar from the lock unit holes A, B, and C.
17. Connect the brake switch connector with the
brake pedal released.
Caution
• The clearance between the brake switch
and the brake pedal is automatically
adjusted to the correct amount when the
brake switch connector is connected
after the brake switch has been properly
installed. If the brake switch is not
properly installed or the connector is
connected before installation, the
clearance may be incorrect, causing a brake light malfunction. Therefore, always verify that the
brake switch is properly installed before connecting the connector.
• Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again.
Therefore, replace the switch with a new one when replacing the power brake unit or the pedal, or
performing any procedure that changes the pedal stroke.
18. Turn the ignition switch to ON position.
19. Install the interlock cable to the steering lock.
20. Slide the outer casing to the steering lock and
insert the clip over the convex part of the outer
casing.
End Of Sie
05-18–12
INTERLOCK
CABLE
LOCK PIECE
INTERLOCK CABLE
UNLOCK
LOCK UNIT
C
B
A
SLIDER PIN
CONVEX PART
CLIP
CLIP
acxuuw00000429
LOCK
acxuuw00000430
INTERLOCK
CABLE
BRAKE SWITCH
acxuuw00000425
acxuuw00001380