Type B Removal - Mazda CX-7 2007 Workshop Manual

Type B Removal

Caution
• Be careful not to damage the pipe when unlocking the retainer.
Note
• When removing the quick connector, either SST 49 E042 001 or 49 N013 103A.
When using SST 49 N013 103A
1. Follow "BEFORE SERVICE PRECAUTION" and remove dirt from the connecting surfaces before performing
any work operations. (See01-14-4 BEFORE REPAIR PROCEDURE[L3 WITH TC].)
2. Insert the SST into the quick release connector.
3. Pull out the fuel hose straight from the fuel pipe
and disconnect it.
4. Cover the disconnected quick release connector
and fuel pipe with vinyl sheeting or a similar
material to prevent it from scratches or dirt.
When using SST 49 E042 001
Note
• If the quick release connector is removed, replace the retainer with a new one.
1. Follow "BEFORE SERVICE PRECAUTION" and remove dirt from the connecting surfaces before performing
any work operations. (See01-14-4 BEFORE REPAIR PROCEDURE[L3 WITH TC].)
Note
• The retainer is attached to the pipe even after the connector is disconnected.
2. Set the SST parallel to the quick release
connector.
Note
• The quick release connector can be
removed by pushing the center of the
retainer tabs.
3. Hold the center of the retainer tabs with the SST
ends and press the retainer.
4. Pull the connector side and disconnect the quick
release connector.
5. Raise a retainer tab using the SST and remove
the retainer.
6. Cover the disconnected quick release connector
and evaporative hose with vinyl sheeting or a
similar material to prevent it from scratches or dirt.
FUEL SYSTEM [L3 WITH TC]
FUEL PIPE
QUICK RELEASE CONNECTOR
49 N013 103A
49 E042 001
49 E042 001
R
01-14
acxuuw00002337
acxuuw00000057
RETAINER
acxuuw00000058
01-14–21