Mazda CX-7 2007 Workshop Manual page 631

02-10 GENERAL PROCEDURES
PRECAUTION (SUSPENSION). . . . . . . . 02-10–1
Wheels and Tires
Removal/Installation. . . . . . . . . . . . . . 02-10–1
Suspension Links
Removal/Installation. . . . . . . . . . . . . . 02-10–1
End of Toc
WM: SUSPENSION PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
1. When a wheel is installed, tighten it to
88.2— 117.6 N·m {9.00— 11.99 kgf·m, 65.06—
86.73 ft·lbf}.
Suspension Links Removal/Installation
1. Tighten any part of the suspension that uses rubber bushings only after the vehicle has been lowered to the
ground and unloaded.
Note
• Unloaded: Fuel tank is full. Engine coolant and engine oil are at specified levels. Spare tire, jack and tools
are in designated position.
Brake Lines Disconnection/Connection
Caution
• Brake fluid will damage painted surfaces. If brake fluid does get on a painted surface, wipe it off
immediately.
1. Tighten the brake pipe flare nut using the SST (49 0259 770B). Be sure to modify the brake pipe flare nut
tightening torque to allow for use of a torque wrench-SST combination.
(See 00-00-13 SERVICE CAUTIONS.)
2. If any brake line has been disconnected anytime during the procedure, add brake fluid, bleed the brakes, and
inspect for leakage after the procedure has been completed.
Power Steering Components Removal/Installation
1. If any steering fluid line has been disconnected, perform the following after installation of the power steering
components.
— Power steering fluid amount inspection
— Power steering fluid leakage inspection
— Air bleeding
Power steering fluid
ATF (M-III or M-V, or equivalent (e.g. Dexron®II))
End Of Sie
GENERAL PROCEDURES
Brake Lines
Disconnection/Connection . . . . . . . . . 02-10–1
Power Steering Components
Removal/Installation . . . . . . . . . . . . . . 02-10–1
id021000800100
1
4 3
2 5
acxuuw00001032
02-10–1
02-10