Front Stabilizer Removal/Installation; Front Stabilizer Installation Note - Mazda CX-7 2007 Workshop Manual

FRONT STABILIZER REMOVAL/INSTALLATION

1. Remove the side cover and under cover.
2. Drain the power steering fluid. (See 06-14-3 POWER STEERING FLUID INSPECTION.)
3. Remove the transverse member. (See 02-13-14 TRANSVERSE MEMBER REMOVAL/INSTALLATION.)
4. Remove the front crossmember component. (See 02-13-10 FRONT CROSSMEMBER REMOVAL/
INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
2
42.3—60.1
{4.32—6.12,
31.2—44.3}
.
1 Front stabilizer component
2 Front stabilizer control link
3 Stabilizer bracket
(See 02-13-9 Stabilizer Bracket Installation Note)

Front Stabilizer Installation Note

1. Install the stabilizer bar so that the identification
mark is on the left side of the vehicle.
02-13–8
FRONT SUSPENSION
5
42.3—60.1
{4.32—6.12,
31.2—44.3}
43.1—60.8
{4.40—6.19,
31.8—44.8}
3
4
RUBBER
GREASE
N·m {kgf·m, ft·lbf}
4 Stabilizer bushing
(See 02-13-9 Stabilizer Bushing Installation Note)
5 Front stabilizer
(See 02-13-8 Front Stabilizer Installation Note)
FRONT
POSITIONING PLATE
IDENTIFICATION
MARK
id021300800400
1
acxuuw00001098
acxuuw00001099