Mazda CX-7 2007 Workshop Manual page 1252

STEP
2 INSPECT ALL SAS CONTROL MODULE
CONNECTORS
• Remove the column cover. (See 09-17-8
COLUMN COVER REMOVAL/
INSTALLATION.)
• Disconnect the clock spring connector.
• Remove the glove compartment.(See 09-17-
8 GLOVE COMPARTMENT REMOVAL/
INSTALLATION.)
• Disconnect the passenger-side air bag
module connector.
• Disconnect the driver and passenger-side
seat connectors.
• Remove the C-pillar trim. (See 09-17-17 C-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Remove the D-pillar trim. (See 09-17-18 D-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Disconnect the driver and passenger-side
curtain air bag module connector.
• Remove the B-pillar lower trim. (See 09-17-
16 B-PILLAR LOWER TRIM REMOVAL/
INSTALLATION.)
• Disconnect the driver and passenger-side
pre-tensioner seat belt connectors.
• Remove the console. (See 09-17-13
CONSOLE REMOVAL/INSTALLATION.)
• Disconnect the SAS control module
connector.
• Are the poor connection detector bars of
SAS control module connectors normal?
End Of Sie
DTC C1947, C1948, C1981
C1947 Seat track position sensor circuit short to body ground
DTC C1948 Seat track position sensor circuit resistance not within specification
C1981 Seat track position sensor circuit open or short to power supply
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
DETECTION
an operating error, or damage the system. When performing an inspection, always follow the
CONDITION
inspection procedure.
• Malfunction in seat track position sensor circuit.
• Malfunction of connector between seat track position sensor and SAS control module.
• Open or short circuit in wiring harness between seat track position sensor and SAS control module.
POSSIBLE
• Seat track position sensor malfunction
CAUSE
• SAS control module malfunction
SAS CONTROL MODULE WIRING
HARNESS-SIDE CONNECTOR
2Y 2V
2Z 2W
2AA 2X
08-02–50
ON-BOARD DIAGNOSTIC
INSPECTION
2S 2P 2M 2J 2G 2D 2A
2T 2H 2E 2B
2U 2R 2O 2L 2I 2F 2C
Yes Replace the SAS control module.
(See 08-10-10 SAS CONTROL MODULE REMOVAL/
INSTALLATION.)
No Replace the air bag wiring harness.
SEAT TRACK POSITION SENSOR
WIRING HARNESS-SIDE CONNECTOR
A
C
*
*
ACTION
id080200803200