Mazda CX-7 2007 Workshop Manual page 1280

Side Air Bag Module
1. Disconnect the front seat connector.
2. Connect the SST (Adapter harness) to the side
air bag module and pre-tensioner seat belt
connector as shown in the figure.
3. Connect the SST (Deployment tool) to the SST
(Adapter harness).
4. Connect the SST (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
5. Verify that the red lamp on the SST (Deployment
tool) is illuminated.
6. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
7. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the side
air bag module.
8. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
Curtain Air Bag Module
1. Remove the C-pillar trim.
(See 09-17-17 C-PILLAR TRIM REMOVAL/INSTALLATION.)
2. Remove the D-pillar trim.
(See 09-17-18 D-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Disconnect the curtain air bag module connector.
4. Connect the SST (Adapter harness) to the
curtain air bag module as shown in the figure.
08-10–20
AIR BAG SYSTEM
FRONT SEAT
CONNECTOR
49 B066 004
49 H066 002
49 H066 002
CURTAIN AIR BAG
MODULE
CURTAIN AIR BAG
MODULE CONNECTOR
acxuuw00001269
49 B066 004
acxuuw00001270
ACTIVATION
SWITCH
acxuuw00001267
49 L066 002
acxuuw00001709