Mazda CX-7 2007 Workshop Manual page 1097

4. Reverse the gear housing, then press the
mounting rubber until the mounting rubber end
comes out completely from the other side. At this
time, make sure that the mounting rubber and
steel pipe are aligned.
Oil Seal Assembly Note
1. Apply ATF to the lip of a new oil seal.
2. Install the SST (49 N032 319A) to the gear housing with the raised part facing up as shown in the figure.
3. Set the stopper into the gear housing to hold the
SSTs as shown in the figure.
4. Install the oil seal using the SSTs (49 F032 303,
49 H032 326) and a press.
Steering Rack Assembly Note
1. Apply multipurpose grease to the rack teeth.
2. Install a plastic bag to the rack teeth and insert
the steering rack in the gear housing.
POWER STEERING
49 B032 317
49 B018 003
MOUNTING RUBBER
STEEL PIPE
49 B032 317
49 B018 003
acxuuw00000997
49 F032 303
49 H032 326
49 N032 319A
acxuuw00000998
PLASTIC BAG
acxuuw00000999
06-14–17
06-14