Mazda CX-7 2007 Workshop Manual page 1297

4. While pulling the seat belt out, make sure that the
seat belt does not lock when the retractor is tilted
slowly up to 15° from the mounted position and
locks when the retractor is tilted 40° or more.
• If there is any malfunction, replace the seat
belt.
ALR
1. Pull the belt out fully to change the lock mode from ELR to ALR.
2. Verify that retractor makes a clicking sound as the belt slowly retracts. If no sound is heard, the lock mode has
not changed to ALR. If necessary, repeat Step 1.
• If there is any malfunction, replace the seat belt.
3. Verify that the retractor locks when pulled.
• If there is any malfunction, replace the seat belt.
4. Verify that the lock mode changes to ELR when the belt is fully pulled out.
• If there is any malfunction, replace the seat belt.
Load Limiter Retractor
Warning
• When the load limiter operates, the belt and anchor rub against each other strongly leaving wear
tracks. If the seat belt is used in this state, the seat belt will not function at its full capability and
there is the possibility of serious injury to passengers. Be sure to replace the seat belt once the
load limiter operates.
1. If the vehicle has been subjected to a shock in an
accident, pull the belt from the retractor and
confirm that there are no wear tracks (the load
limiter has not operated) by visually inspecting
and feeling the belt.
• If there is any malfunction, replace the seat
belt.
End Of Sie
WM: FRONT BUCKLE
FRONT BUCKLE REMOVAL/INSTALLATION
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the front seat. (See 09-13-2 FRONT SEAT REMOVAL/INSTALLATION.)
4. Detach the tab as shown in the figure and remove
the connector from the front seat connector.
SEAT BELT
RETRACTOR
BELT
PULL
acxuuw00002084
ANCHOR
TRACE
OF WEAR
acxuuw00002085
id081100800400
FRONT SEAT
CONNECTOR
TAB
FRONT BUCKLE
CONNECTOR
acxuuw00001028
08-11–5
08-11