Mazda CX-7 2007 Workshop Manual page 1098

Stopper Assembly Note
1. Using an appropriate pipe and a hammer, insert
the rack stopper into the gear housing until the
clip installation groove of the gear housing comes
out.
2. Apply 53.3 kPa {400 mmHg, 15.8 inHg} vacuum
with a vacuum pump and verify that it is held for
30 s.
• If the vacuum is not held, replace the oil seal.
Oil seal (Upper side) Assembly Note
1. Assemble the oil seal (upper side) using the SST.
Substitution SST
• 49 H032 327
Outer diameter: 30— 34 mm {1.2— 1.3 in}
• 49 H032 334
Outer diameter: 30— 32 mm {1.19— 1.25 in}
Bearing (upper side) Assembly Note
1. Assemble the bearing (upper side) using the SST.
Substitution SST
• 49 H032 327
Outer diameter: 30— 34 mm {1.2— 1.3 in}
06-14–18
POWER STEERING
acxuuw00001000
49 G032 3A1
acxuuw00001001
49 H032 327
49 H032 334
acxuuw00001002
49 H032 327
acxuuw00001003