Mazda CX-7 2007 Workshop Manual page 749

Spacer, Bearing Inner Race Assembly Note
Pinion height adjustment
Note
• Use the same spacer.
• Install the spacer with the chamfer on the SST side.
1. Assemble the spacer, the bearing inner race (rear
bearing), and the SST O-ring to the SST (49 8531
565) as shown in the figure.
2. Insert the set assembled in Step 1 to the
differential gear from the rear.
3. Assemble the bearing inner race (front bearing),
SST (49 G027 005), companion flange, washer,
and locknut from the front of the differential gear.
4. Tighten the locknut to the extent that the SST (49
8531 565) can be turned by hand.
5. Place the SST (49 0305 555) on top of the SST
(49 8531 565).
6. Place the SST on the surface plate and set the
dial indicator to zero.
7. Set the SST as shown in the figure.
8. Place the measuring probe of the dial indicator so
that it contacts the place where the side bearing is
installed in the carrier. Then measure the left and
right side of the lower position.
DIFFERENTIAL
49 0305 555
49 8531 565
49 8531 568
49 G027 005
49 G032 347
acxuuw00001422
49 0727 570
acxuuw00001423
49 0727 570
acxuuw00001424
03-14–13
03-14