Mazda CX-7 2007 Workshop Manual page 1283

4. Stack three tires without wheels on top of the tire
with the driver-side air bag module, and then
stack another tire with a wheel on the very top.
5. Secure the tires with wire.
6. Connect the SSTs (Deployment tool) to the
SSTs (Adapter harness).
7. Connect both SSTs (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
8. Verify that the red lamp on both SSTs
(Deployment tool) is illuminated.
9. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
10. Press the activation switch on the SST
(Deployment tool) connected with 49 L066 002
(a yellow connector) of the SST (Adapter
harness), and after 3 s, press the activation
switch on other SST (Deployment tool) to
operate (deploy) the air bag module (both
inflators).
Warning
• Verify that air bag module operation
(explosive) sound occurs twice. If no
operation (explosive) sound was heard or
a single operation (explosive) sound was
heard, both inflators would not have
operated (deployed) properly. This may cause serious injury if the air bag module operates
(deploy) unexpectedly. If the two operation (explosive) sounds are not heard, perform Step 8 again.
If a total of two operation (explosive) sounds cannot be verified even though Step 8 is performed
again, leave the air bag module alone for 30 min or more before approaching it again.
• The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do
not touch the air bag module for at least 15 min after deployment.
11. Disconnect the SSTs (Deployment tool) from the SSTs (Adapter harness).
AIR BAG SYSTEM
TIRE
WITHOUT
WHEEL
49 H066 002
49 H066 002
49 G066 003
49 H066 002
49 L066 002
TIRE WITH
WHEEL
TIRE WITH
DRIVER-SIDE
AIR BAG
MODULE
acxuuw00001275
acxuuw00001276
08-10
acxuuw00001277
ACTIVATION
SWITCH
acxuuw00001267
08-10–23