Mazda CX-7 2007 Workshop Manual page 1011

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
2 Transaxle fluid temperature (TFT) sensor
(See 05-17-12 TRANSAXLE FLUID
TEMPERATURE (TFT) SENSOR
INSPECTION[AW6A-EL, AW6AX-EL].)
(See 05-17-13 TRANSAXLE FLUID
TEMPERATURE (TFT) SENSOR REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
3 Input/turbine speed sensor
(See 05-17-15 INPUT/TURBINE SPEED SENSOR
INSPECTION[AW6A-EL, AW6AX-EL].)
(See 05-17-17 INPUT/TURBINE SPEED SENSOR
REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
4 Vehicle speed sensor
(See 05-17-18 VEHICLE SPEED SENSOR (VSS)
INSPECTION[AW6A-EL, AW6AX-EL].)
(See 05-17-19 VEHICLE SPEED SENSOR (VSS)
REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
5 Solenoid valve
(See 05-17-20 SOLENOID VALVE
INSPECTION[AW6A-EL, AW6AX-EL].)
6 TCM
(See 05-17-11 TRANSAXLE RANGE (TR)
SWITCH INSPECTION[AW6A-EL, AW6AX-EL].)
(See 05-17-21 TCM INSPECTION[AW6A-EL,
AW6AX-EL].)
(See 05-17-25 TCM REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
7 Oil seal (manual shaft)
(See 05-17-28 OIL SEAL (MANUAL SHAFT)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
End Of Sie
MECHANICAL SYSTEM TEST[AW6A-EL, AW6AX-EL]
Mechanical System Test Preparation
1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
2. Inspect the engine coolant level. (See 01-12-2 COOLING SYSTEM SERVICE WARNINGS[L3 WITH TC].) (See
01-12-3 ENGINE COOLANT LEVEL INSPECTION[L3 WITH TC].)
3. Inspect the engine oil level. (See 01-11-3 ENGINE OIL LEVEL INSPECTION[L3 WITH TC].)
4. Inspect the ATF level. (See 05-17-10 AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION[AW6A-EL,
AW6AX-EL].)
5. Inspect the idle speed. (See 01-10-35 ENGINE TUNE-UP[L3 WITH TC].)
6. Inspect the ignition timing. (See 01-10-35 ENGINE TUNE-UP[L3 WITH TC].)
Line Pressure Test
1. Perform mechanical system test preparation. (See05-17-3 Mechanical System Test Preparation.)
2. Remove the harness bracket.
Warning
• Removing the test plug when the ATF is
hot can be dangerous. Hot ATF can come
out of the opening and badly burn you.
Before removing the test plug, allow the
ATF to cool.
8 Automatic transaxle
(See 05-17-29 AUTOMATIC TRANSAXLE
REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
9 Oil seal (differential)
(See 05-17-35 OIL SEAL (DIFFERENTIAL)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
10 Differential gear O-ring
(See 05-17-37 DIFFERENTIAL GEAR O-RING
REPLACEMENT[AW6A-EL, AW6AX-EL].)
11 Control valve body
(See 05-17-38 CONTROL VALVE BODY
REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
12 Torque converter
(See 05-17-46 TORQUE CONVERTER REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
13 Oil seal (oil pump)
(See 05-17-45 OIL SEAL (OIL PUMP)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
14 Oil cooler
(See 05-17-47 OIL COOLER FLUSHING[AW6A-
EL, AW6AX-EL].)
(See 05-17-47 OIL COOLER REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
(See 05-17-50 OIL COOLER DISASSEMBLY/
ASSEMBLY[AW6A-EL, AW6AX-EL].)
15 Drive plate
(See 05-17-52 DRIVE PLATE REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
HARNESS BRACKET
7.8—10.8 N·m
{80—110 kgf·cm,
70—95 in·lbf}
05-17
id051723802100
acxuuw00002187
05-17–3