Mazda CX-7 2007 Workshop Manual page 763

TRANSFER OIL COOLER REMOVAL/INSTALLATION
1. Disconnect the propeller shaft from the transfer side. (See 03-15-3 PROPELLER SHAFT REMOVAL/
INSTALLATION.)
2. Drain the engine coolant. (See 01-12-5 ENGINE COOLANT REPLACEMENT[L3 WITH TC].)
3. Drain the transfer oil into a suitable container. (See 03-16-2 TRANSFER OIL REPLACEMENT.)
4. Remove in the order indicated in the figure.
5. Install in the reverse order of removal.
6. Perform the following procedure, if the transfer has been overhauled and installed to the vehicle.
(1) After warming up the engine, drive the vehicle and inspect for oil leakage and abnormal noise.
.
1 Water hose
2 Transfer oil cooler installation bolt
End Of Sie
TRANSFER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
(1) Battery, battery try (See 01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC].)
(2) Engine cover
(3) Intercooler (See 01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
(4) Front pipe (See 01-15-2 EXHAUST SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
3. Disconnect the propeller shaft from the transfer side. (See 03-15-3 PROPELLER SHAFT REMOVAL/
INSTALLATION.)
4. Remove the transfer oil cooler withe the hose still connected. (See 03-16-3 TRANSFER OIL COOLER
REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Warm up the engine and transaxle, inspect for oil leakage, and inspect the transfer operation.
TRANSFER
23.5—29.4 N·m
{2.4—2.9 kgf·m, 17.4—21.6 ft·lbf}
R
R
3 Transfer oil cooler
id031600800500
03-16
E6U316ZWC007
id031600800600
03-16–3